Our Roofing Process

Our Roofing Process


    1. Lifestyle does an initial evaluation with the property owner to determine their needs. This includes proper ventilation, leak prevention, foundation issues, decking problems, and anything else we can find that would affect the outcome of a job well done.


    1. Once we remove the shingles from the roof, we will evaluate the decking to ensure we have a proper nailable surface up to building code


    1. Lifestyle will felt the entire roof surface covering all hip and ridge joints using roofing felt. Roofing felt is a type of tar paper that acts as a moisture barrier.


    1. During the felting process Lifestyle will install chimney flashing, step flashing, or any other type of flashing so water doesn’t find its way into the home.two men working on roofing a house
    2. Once the felt is secure, we will install drip edge on the eaves, and then ice and water shield in all the valleys, dead valleys, and chimney areas. Ice and water shield is an additional defense against leaking that the insurance does not always pay for, and most roofers will not install it because of cost.


    1. Right before we begin roofing, Lifestyle installs a starter course of shingles on the eaves and rakes called Pro-Start or starter course. The first shingles we install will have a type of tar on the shingle edge that allows the shingles to stick together. This prevents potential leaks and curling over time.


    1. Lifestyle’s installation crews always use a chalk line to ensure the shingles are installed in a straight line on each slope. Lifestyle uses coiled nails rather than staples to reduce the likelihood of them backing out or damaging the decking.


    1. Once the slopes have been roofed, we install all hip and ridge shingles. Our customers have their choice to install a 3-tab ridge, Z ridge, Timbertex, or a type of high profile ridge based on their personal choice.image of a finished roof


    1. Lifestyle’s roofers will then blow all the loose debris off the roof and caulk all vulnerable areas. We then install all roof metal including but not limited to wind turbines, 750 vents, power vent covers, heater vent caps, flu caps, and flashing where it is needed. We then caulk the roof again just to make sure we get all vents and boots that were just installed.


    1. Lifestyle uses a 3-foot magnet around the property to remove any nails, metal materials, or loose debris for dumping. All garbage and debris will be removed daily and at the completion of the job.


  1. Once the roof is complete, we then do a final walk around with the homeowner to ensure satisfaction.

Contact us today at our Blanchard location (405) 470-6999 or our OKC (405) 485-9939 or fill our contact form today!